ACL AL Main Bearings 0.5mm 3S-GTE Gen 2 SW20 ST185 3S-GTE Gen 3 JDM SW20 ST205 5S-FE

One often overlooked part when building an engine is the bearings. Getting a quality set of bearings can directly determine the longevity of your engine. The -.50 on the end of this part number means that the bearing is thicker than a standard bearing. These should be used when your crank has been cut .50mm (.020") under.
The introduction of Aluglide bearings is another example of ACL’s commitment to understanding and adapting to customer requirements.This is currently the choice of most Original Equipment (OE) manufacturers as the global mandate to have Lead free vehicles is enforced.