These are our 950HP 3.5" Heavy Duty Carbon Fiber drive shafts for the Eclipse and Talon. This shaft is designed to replace the first 2 shafts of the factory 3-piece system. We were going to try to make a single shaft but due to Critical speed limitations it would need to be 4" in diameter and would not fit under the car and also the operating angles would not allow for a 1-piece shaft to work. The front angle was 2 degrees and the back was 7 degrees (not good), the problem is the rear joint would move more than 2 times as much as the front and cause a very nasty vibration. The AE-7 manual of Automotive engineers doesn't recommend any driveshaft to have more than a 1 degree difference from one operating angle to the other (this would be a 5 degree spread). This shaft comes complete with a conversion plate for the CV end and all hardware to make this a job that can be done in the garage. This Heavy Duty shaft is rated for 950HP.
Driveshaft has a 25 Spline Yoke for Shep Trans Case Upgrade
Warranty: 1 year
Special Notes: Heavy Duty version replaces the first 2 of the 3 shafts, saves 40% weight and is rated to 950HP
Specifications
More Information
Old Part Number
MISH2-HD25-C
Note
3.5" 950hp, for 25 spline yoke Shep Trans Case Upgrade
Note
25 Spline Yoke for Shep Trans Case Upgrade. Driveshaft replaces the first 2 of the 3 shafts. AWD only
Shipping Weight (Dimensional)
25.000000
Clearance Sale
No
Availability
Call
Part Type
Driveshafts
Make
Mitsubishi
Vehicle Model
Eclipse GSX / Talon TSI AWD
Model
Eclipse GSX AWD 95-99 2G
Engine
4G63T (7-Bolt DSM / Evo 1-3)
Transmission
W5M33 AWD 5spd Manual, W4A33-1 AWD 4spd Automatic
HP Rating
950
Brand
Driveshaft Shop
Driveshaft Material
Carbon Fiber
Carb Legal
Unspecified
Shipping Label
Free Shipping
Reviews
Write Your Own Review
Related Items List (3)
Real Street T-Shirt Black w/ Green & White LogoSKU#RS-TSHIRT