HPS Red Air Intake 06-09 S2000 AP2 2.2L F22 drive-by-wire 27-610R

HPS 4-Ply Reinforced High Temp Red Silicone Shortram Air Intake Kit with K&N filter replaces the S2000 AP2 2.2L F22 drive-by-wire stock OEM restrictive rubber intake hose with high temp reinforced silicon material and replace the OEM cone filter with the bigger K&N performance air filter. HPS performance silicone shortram air intake kit improves air flow and throttle response, minimize the amount of heat soak by retaining the stock fresh air scoop and sealed air box design. The included air velocity stack also smooth out the air flow and reduce the amount of turbulence. Without any re-tuning, the HPS silicone post MAF air intake tube with K&N performance air filter delivers dyno-proven performance gains - increase horsepower +4.9 Whp , torque +3.4 Ft/lbs. The intake kit also makes the S2K sound louder and more aggressive compare to the stock intake setup. This silicone intake kit does NOT trigger check engine light. Installation time is approx. 1.5 to 2 hours. Modification is required in order to fit the large K&N filter into the stock air box, which requires trimming the lid in the lower air intake box and removal of the internal snorkel in the upper air intake box. The included K&N High-Flow conical air filter designed to provide increased surface area and dust capacity compare to the OEM air filter. This extra surface area provides even more airflow at lower restriction than a standard replacement filter that is limited to the size of the factory air box. The oversize air filter also captures more dirt increasing the service life before a cleaning is required (up to 100,000 miles).

Key Features:
- Replace the stock oem restrictive rubber intake hose and improve air flow, throttle response and reduce heat soak.
- Dyno-proven performance gains - increase horsepower +4.9 Whp , torque +3.4 Ft/lbs.
- For maximum cooling effect, retain stock fresh air scoop and sealed intake box design.
- The included air velocity stack also smooth out the air flow and reduce the amount of turbulence.
- Makes the S2000 sound louder and more aggressive compare to the stock setup
- Includes K&N High-Flow, Washable/Reusable Air Filter which is backed by Million Mile Limited Warranty
- 100% Stainless Steel T-Bolt Clamps is included
- Re-tuning is NOT required. Does NOT trigger check engine light.
- Modification is required in order to fit the large K&N filter into the stock air box, which requires trimming the lid in the lower air intake box and removal of the internal snorkel in the upper air intake box.

Product Specifications
- Material: 4-Ply Reinforced High Temp Silicone
- Color: Red
- CARB Exempt: No
- System Type: Silicone Air Intake system
- Vehicle Application: 2006-2009 Honda S2000 AP2 2.2L F22 drive-by-wire.