Driveshaft Shop 1400HP Pro-Level Axles Hubs Kit 1993-1998 Supra Turbo Manual Transmission 2JZ-GTE

Here is the Pro-Level Rear Axle/Hub kit for the 1993-1998 Supra Turbo Manual. The new Pro-Level Axle/Hub kit feature our largest 30 spline aerospace grade torsional axle bars, 108mm Porsche-style outer/inner CV with a newly designed bolt-on outer stub that is made to fit the Supra suspension and is machined to accept the Supra ABS rings. This kit is a complete system with both axles, wheel hubs with the larger spline to accommodate the new outer CV, ARP extended studs and adaptor plate and all the hard were you the factory outer stub. This system is designed for pro drag race use but is suitable for any street car. Rated to 1200HP with a 1-year warranty.

Please Note: This set is for the Manual rear differential ONLY, if you are using the automatic differential please see part# TO55



* current design requires the casting that holds the ABS sensor to be ground down a little bit, this is a very simple thing taking about 5-10 minutes .The spindle will be off the car for the hubs to be changed so please do this then, look for picture and text as to what to do in the box. Alldata gives 5.4 hours for the bearing change alone not to mention the studs being pressed and the time for the car to be re-aligned. (futher designs will not require the grinding of the small ring) ABS ring if being re-used have to be changed over from the factory axle to this kit. 

**U.S. Models Only**