Magnus 9.7 GPM MF Mechanical Fuel Pump Kit Acura Honda K Series Leaned Motor Using Race ATI Damper

Introducing the Magnus MF K Series Mechanical fuel kit. Sick of the problems and short-comings of electric pumps? Want the ultimate in reliability?

The heating of the fuel associated with running multiple pumps can cause serious tuning issues, or in more serious circumstances can cause the engine to lean out during high rpm/high boost situations. The mechanical fuel pump adds no additional heat to the fuel keeping it cool and consistent. With more than enough flow to support any horsepower levels with absolutely no drop in pressure. This fuel pump has been proven to supply over 180psi at the rail. Added features of the a mechanical fuel pump system are over lighter one small pump will supply all the fuel you need. Less complication, No multiple pumps needed. with No wiring and No ECU controlled outputs, No added electrical system draw, No additional transformers, or something additional to worry about tuning. Only one pump is needed driven directly from the engine. Follows the keep it simple principal.

Every component is designed and built in house to the strictest tolerances. Lightweight 3 bolt crank drive gear is the lightest on the market, as well a the Fuel pump drive gear was designed to be as light as possible as well. All wear parts are hard anodized for superior reliability.

Designed for use with Magnus MF Fuel Pump

Features:

• Driven from Crank of the Honda K series (Requires Race ATI Balancer)
• Can be used with multiple fuels (Gas, Methanol, and Ethanol)
• Simplifies your fuel system
• Increases reliability -No more need for multiple electric pumps
• Increases safety – in case of fire or engine failure engine, pumps shuts off cutting the fuel supply to fire
• Decreased heating of fuel
• 9.7 GPM at 40psi
• 8.5 GPM at 60psi
  
  

Magnus MF Mechanical fuel pump Belt Drive 1/2" with .125" Keyed and same side inlet and outlet

Magnus Motorsports announces the release of their Multiple Fuel (MF) Mechanical Fuel Pump compatible with gas, methanol, and ethanol.

Magnus Motorsports has designed their MF Fuel Pump with the inlet and exit of fuel lines on the same side of the pump, thereby eliminating the need for any additional types of fittings such as elbows and u-bends. This is especially beneficial in the tight confines of transverse motor configurations. The MF Fuel Pump is configured with an industry standard keyed 1/2 inch shaft with 1/8 key. The compact design of the fuel pump results in ease of mounting positions.

The MF Fuel Pump is constructed of out of billet aluminum. Internal hardened gears are hand lapped increase lifespan and reduce the coefficient of friction. The gear housing is constructed from Anti-Galling and corrosion resistant material and further DLC coated to resist the low lubricant properties of alcohol based fuels.

Its small size and weight can supply huge amounts of fuel. The Magnus MF Mechanical fuel pump supports up to:

9.7 GPM @ 40 psi relative pressure @ 80% IDC with at 5000 RPM of pump speed (1/2 engine speed) 2800HP on Methanol 4300HP on Ethanol 5700HP on Gas

8.5 GPM @ 60 psi relative pressure @ 80% IDC with at 5000 RPM of pump speed (1/2 engine speed) 2500HP on Methanol 3700HP on Ethanol 5000HP on Gas

Allow 20 percent more headroom for your fuel system