PHR Ford IAC Adapter Kit for 2JZ-GTE

Finally, a solution to the 2JZ-GTE idle motors. Factory stepper motors require 4 wires to operate. The PHR Ford IAC Adapter Kit for 2JZ-GTE only requires a single output from your ecu, freeing up 3 additional outputs. This is extremely helpful on ECU's like MoTeC M600, M84 and other where outputs are limited. If your ECU is limited on outputs, this is the solution you need to free up your outputs for other needs.
Note: A scenario which would cause the valve to seem inoperable is if there is not enough vacuum in the intake manifold, the valve will never close and will sit in the open position, not responding. The valve has to be sucked closed in order to properly operate. If your throttle body is open too far with the idle screw, or your camshafts are very large, these will both reduce vacuum. A vacuum leak can also cause a reduction in vacuum.

In addition, the factory idle motors are extremely expensive to replace and are very difficult to find used in good condition. This provides an affordable alternative for those running aftermarket ECU's when their idle motor fails.

Can be run with a filter attached directly to the IAC or 3/4" hose to the intake pipe or other location for IAC filtration. You will need to continue using the factory check valve, grommet and gasket to keep from leaking boost. Only replace the motor and housing.