Wilwood Dynapro Radial Front Drag Brake Kit Ano 12.90 2 pc Drilled Rotors Mustang Ecoboost 15-21

VEHICLE MODELS:

Ford Mustang 2015 Base
Ford Mustang 2019 Bullitt
Ford Mustang EcoBoost 2015-2021
Ford Mustang EcoBoost Premium 2015-2021
Ford Mustang GT 2015-2021 (except GT350)
Ford Mustang 2015 GT 50 Years Anniversary Edition (except GT350)
Ford Mustang GT Premium 2015-2021 (except GT350)
Ford Mustang V6 2016-2017

Note:Brake Kits are designed to fit OE Factory Spindles. Contact us if you are not using a factory spindle.

Dynapro Radial Front Drag Brake Kit

DynaPro4R Drag Race front brake kits deliver high torque stopping power with a substantial weight savings over the OE brake components. Dynamic mount steel rotors weigh only 5.7 pounds each. They attach to the OE hubs with lightweight forged aluminum hats using our T-nut mounting system that allows the rotor to move independently of the hat during heat cycles. This eliminates stress at the mount points and the subsequent rotor distortion that can otherwise occur with fixed mount steel plate rotors. Dynamic mount rotors also assure full release from the pads to run true and drag free down the track. Clamping force is provided by radial mount DynaPro 4R four piston aluminum calipers weighing in at only 4.1 pounds each. DP4R calipers feature stainless steel pistons, internal bore seals, stainless steel bridge wear plates, and allow easy access to the pads for service without removing the calipers from the mount. BP-20 compound SmartPads provide high response and holding power when cold, and resistance to fade when hot. The complete package mounts to the OE spindle with full bolt-on installation. This kit is configured for drag racing only and is not recommended for street use. A minimum size 17” wheels are required along with a stainless steel braided flexline kit available separately.

*This Brake Kit may fit 17-inch wheels. Please refer to the wheel clearance diagram to check to see if it will fit your specific wheel.